Format

Send to

Choose Destination
Clin Neuroradiol. 2019 Dec;29(4):645-651. doi: 10.1007/s00062-018-0722-0. Epub 2018 Aug 21.

MDCT-based Finite Element Analysis of Vertebral Fracture Risk: What Dose is Needed?

Author information

1
Engineering Product Development (EPD) Pillar, Singapore University of Technology and Design (SUTD), 8 Somapah Road, 487372, Singapore, Singapore.
2
Department of Radiology, Klinikum rechts der Isar, Technical University of Munich, Munich, Germany.
3
Department of Neuroradiology, Klinikum rechts der Isar, Technical University of Munich, Munich, Germany.
4
Engineering Product Development (EPD) Pillar, Singapore University of Technology and Design (SUTD), 8 Somapah Road, 487372, Singapore, Singapore. subburaj@sutd.edu.sg.

Abstract

PURPOSE:

The aim of this study was to compare vertebral failure loads, predicted from finite element (FE) analysis of patients with and without osteoporotic vertebral fractures (OVF) at virtually reduced dose levels, compared to standard-dose exposure from multidetector computed tomography (MDCT) imaging and evaluate whether ultra-low dose derived FE analysis can still differentiate patient groups.

MATERIALS AND METHODS:

An institutional review board (IRB) approval was obtained for this retrospective study. A total of 16 patients were evaluated at standard-dose MDCT; eight with and eight without OVF. Images were reconstructed at virtually reduced dose levels (i. e. half, quarter and tenth of the standard dose). Failure load was determined at L1-3 from FE analysis and compared between standard, half, quarter, and tenth doses and used to differentiate between fracture and control groups.

RESULTS:

Failure load derived at standard dose (3254 ± 909 N and 3794 ± 984 N) did not significantly differ from half (3390 ± 890 N and 3860 ± 1063 N) and quarter dose (3375 ± 915 N and 3925 ± 990 N) but was significantly higher for one tenth dose (4513 ± 1762 N and 4766 ± 1628 N) for fracture and control groups, respectively. Failure load differed significantly between the two groups at standard, half and quarter doses, but not at tenth dose. Receiver operating characteristic (ROC) curve analysis also demonstrated that standard, half, and quarter doses can significantly differentiate the fracture from the control group.

CONCLUSION:

The use of MDCT enables a dose reduction of at least 75% compared to standard-dose for an adequate prediction of vertebral failure load based on non-invasive FE analysis.

KEYWORDS:

Finite element analysis; Multidetector computed tomography; Osteoporosis; Radiation dosage; Spinal fractures

PMID:
30132090
DOI:
10.1007/s00062-018-0722-0

Supplemental Content

Full text links

Icon for Springer
Loading ...
Support Center