Format

Send to

Choose Destination
Rev Sci Instrum. 2018 Feb;89(2):024703. doi: 10.1063/1.5023406.

A practical double-sided frequency selective surface for millimeter-wave applications.

Author information

1
School of Electronics Engineering, Kyungpook National University, 80 Daehak-ro, Buk-gu, Daegu 41566, South Korea.
2
Department of Aviation Information and Communications Engineering, Kyungwoon University, 730 Gangdong-ro, Sandong-myeon, Gumi 39160, South Korea.

Abstract

Analysis, design, and implementation of a practical, high-rejection frequency selective surface (FSS) are presented in this paper. An equivalent circuit model is introduced for predicting the frequency response of the FSS. The FSS consists of periodic square loop structures fabricated on both sides of the thin dielectric substrate by using the low-cost chemical etching technique. The proposed FSS possesses band-stop characteristics and is implemented to suppress the 170 GHz signal with attenuation of more than 45 dB with insensitivity to an angle of incident plane wave over 20°. Good agreement is observed among calculated, simulated, and measured results. The proposed FSS filter can be used in various millimeter-wave applications such as the protection of imaging diagnostic systems from high spurious input power.

PMID:
29495816
DOI:
10.1063/1.5023406

Supplemental Content

Full text links

Icon for American Institute of Physics
Loading ...
Support Center