Format

Send to

Choose Destination
J Biol Regul Homeost Agents. 2018 Jan-Feb;32(2 Suppl. 1):223-229.

FDPS finish line design and tooth preparation technique.

Author information

1
Department of Clinical Science and Translational Medicine, University of Rome “Tor Vergata”, Rome, Italy.
2
Department of Medicine and Surgery, University of Insubria, Varese, Italy.
3
Department of Dentistry “Fra G.B. Orsenigo-Ospedale San Pietro F.B.F.”, Rome, Italy.
#
Contributed equally

Abstract

The purpose of this research is to perform and verify the “modified 50° preparation” suggested by the authors. This procedure was performed with a scrupulous standardization of the tooth’s preparation and then of the laboratory techniques to produce a metal-ceramic crown, and the same for the crown cementation technique of on the preparation of the original sample. After the esthetic evaluations, the obtained sample was included in EPON resin and sectioned in the lingual-vestibular sense. The sections were then observed with an optical microscope in different magnifications for the final evaluations. The geometric design proposed presents the advantages of two great preparation techniques: 50° preparation and circumferential shoulder. The 50° bevel designed in first phase of preparation and the second phase of the circumferential 27° shoulder, together allowed to satisfy the following requirements: aesthetic, marginal accuracy, periodontal compliance, conservation and stability. However, this type of prosthetic preparation is not the only one, but it is one of the marginal designs in prosthetic dentistry.

PMID:
29460546
[Indexed for MEDLINE]

Supplemental Content

Loading ...
Support Center