Format

Send to

Choose Destination
Am J Orthod Dentofacial Orthop. 2017 May;151(5):949-956. doi: 10.1016/j.ajodo.2016.10.028.

Addition of ammonium-based methacrylates to an experimental dental adhesive for bonding metal brackets: Carious lesion development and bond strength after cariogenic challenge.

Author information

1
Graduate Program in Dentistry, Federal University of Sergipe, Aracaju, Sergipe, Brazil.
2
Graduate Program in Dentistry, Federal University of Pelotas, Pelotas, Rio Grande do Sul, Brazil.
3
Department of Restorative Dentistry, Oregon Health & Science University, Portland, Ore.
4
Graduate Program in Dentistry, Federal University of Sergipe, Aracaju, Sergipe, Brazil. Electronic address: fariaesilva.andre@gmail.com.

Abstract

INTRODUCTION:

In this study, we evaluated the caries inhibition and shear bond strength achieved with the addition of the antibacterial monomer [2-(Methacryloyloxy)ethyl] trimethylammonium chloride (MADQUAT) to an adhesive used to bond orthodontic brackets.

METHODS:

Experimental adhesives were formulated with addition of 0% (control), 5%, or 10% MADQUAT followed by measurement of the degree of conversion. These adhesives were used to lute brackets to the enamel of premolars (n = 30). Biofilm from a microcosm model was cultivated in half of the specimens under cariogenic challenge for 5 days. The brackets were subjected to a shear bond strength test followed by measurement of the internal hardness of the enamel around the brackets to calculate the integrated mineral loss.

RESULTS:

The addition of MADQUAT slightly increased the degree of conversion. Adhesive containing 10% MADQUAT significantly reduced the integrated mineral loss around the bracket but also resulted in the lowest values of bond strength. No effects on bond strength and integrated mineral loss were observed with the addition of 5% MADQUAT to the adhesive. The cariogenic challenge did not affect the bond strength and the failure mode.

CONCLUSIONS:

MADQUAT was effective to reduce the integrated mineral loss only when added to the adhesive at a concentration of 10% despite the reduction of bond strength.

Comment in

PMID:
28457273
DOI:
10.1016/j.ajodo.2016.10.028
[Indexed for MEDLINE]

Supplemental Content

Full text links

Icon for Elsevier Science
Loading ...
Support Center