Format

Send to

Choose Destination
J Orthop Res. 2017 Dec;35(12):2765-2772. doi: 10.1002/jor.23572. Epub 2017 May 23.

Stability of small pegs for cementless implant fixation.

Author information

1
Biomechanics Group, Department of Mechanical Engineering, Imperial College London, Exhibition Road, SW7 2AZ London, United Kingdom.
2
Musculoskeletal Surgery Group, Department of Surgery and Cancer, Imperial College London School of Medicine, W6 8RF London, United Kingdom.

Abstract

Most glenoid implants rely on large centrally located fixation features to avoid perforation of the glenoid vault in its peripheral regions. Upon revision of such components there may not be enough bone left for the reinsertion of an anatomical prosthesis. Multiple press-fit small pegs would allow for less bone resection and strong anchoring in the stiffer and denser peripheral subchondral bone. This study assessed the fixation characteristics, measured as the push-in (Pin ) and pull-out (Pout ) forces, and spring-back, measured as the elastic displacement immediately after insertion, for five different small press-fitted peg configurations manufactured out of UHMWPE cylinders (5 mm diameter and length). A total of 16 specimens for each configuration were tested in two types of solid bone substitute: Hard (40 PCF, 0.64 g/cm3 , worst-case scenario of Pin ) and soft (15 PCF, 0.24 g/cm3 , worst-case scenario of spring-back and Pout ). Two different diametric interference-fits were studied. Geometries with lower stiffness fins (large length to width aspect ratio) were the best performing designs in terms of primary fixation stability. They required the lowest force to fully seat, meaning they are less damaging to the bone during implantation, while providing the highest Pout /Pin ratio, indicating that when implanted they provide the strongest anchoring for the glenoid component. It is highlighted that drilling of chamfered holes could minimize spring-back displacements. These findings are relevant for the design of implants press-fitted pegs because primary fixation has been shown to be an important factor in achieving osseointegration and longevity of secondary fixation. © 2017 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 35:2765-2772, 2017.

KEYWORDS:

cementless implant fixation; glenoid; interference fit; press-fit; shoulder

Supplemental Content

Full text links

Icon for Wiley Icon for PubMed Central
Loading ...
Support Center