Format

Send to

Choose Destination
See comment in PubMed Commons below
Environ Monit Assess. 2016 Nov;188(11):647. Epub 2016 Oct 29.

Developing monitoring plans to detect spills related to natural gas production.

Author information

  • 1National Energy Technology Laboratory, 3610 Collins Ferry Road, Morgantown, WV, 26507, USA.
  • 2Department of Civil and Environmental Engineering, West Virginia University, PO Box 6103, Morgantown, WV, 26506, USA.
  • 3U. S. Bureau of Reclamation, 555 Broadway NE, Albuquerque, NM, 87102-2352, USA.
  • 4Department of Civil and Environmental Engineering, West Virginia University, PO Box 6103, Morgantown, WV, 26506, USA. Leslie.Hopkinson@mail.wvu.edu.

Abstract

Surface water is at risk from Marcellus Shale operations because of chemical storage on drill pads during hydraulic fracturing operations, and the return of water high in total dissolved solids (up to 345 g/L) from shale gas production. This research evaluated how two commercial, off-the-shelf water quality sensors responded to simulated surface water pollution events associated with Marcellus Shale development. First, peak concentrations of contaminants from typical spill events in monitored watersheds were estimated using regression techniques. Laboratory measurements were then conducted to determine how standard in-stream instrumentation that monitor conductivity, pH, temperature, and dissolved oxygen responded to three potential spill materials: ethylene glycol (corrosion inhibitor), drilling mud, and produced water. Solutions ranging from 0 to 50 ppm of each spill material were assessed. Over this range, the specific conductivity increased on average by 19.9, 27.9, and 70 μS/cm for drilling mud, ethylene glycol, and produced water, respectively. On average, minor changes in pH (0.5-0.8) and dissolved oxygen (0.13-0.23 ppm) were observed. While continuous monitoring may be part of the strategy for detecting spills to surface water, these minor impacts to water quality highlight the difficulty in detecting spill events. When practical, sensors should be placed at the mouths of small watersheds where drilling activities or spill risks are present, as contaminant travel distance strongly affects concentrations in surface water systems.

KEYWORDS:

Hydraulic fracturing; Spill detection; Surface water; Water monitoring; Water quality

PMID:
27796832
DOI:
10.1007/s10661-016-5641-4
[PubMed - indexed for MEDLINE]
PubMed Commons home

PubMed Commons

0 comments
How to join PubMed Commons

    Supplemental Content

    Full text links

    Icon for Springer
    Loading ...
    Support Center