Emi1 Is Required for an Irreversible G1/S Transition
(A) Stochastic simulation of Emi1 depletion. The initial state of the model corresponds to an S-phase cell (CyclinA increasing, CyclinE decreasing, and p27Kip1 level is low, see C). At t = 5h, the level and rate of synthesis of Emi1 were reduced by 90%, causing APC/CCdh1 reactivation, loss of CyclinA, and accumulation of p27Kip1 and CyclinE. Later, the re-accumulation of CyclinE promotes the re-degradation of p27Kip1.
(B) DNA re-replication after Emi1 depletion. FACS plots of control (left) and Emi1-depleted (right) cells at 0, 24, and 48 hr after release from thymidine. Numbers shown on each graph are the percentage of cells with DNA > 4n.
(C) Experimental measurement of CyclinA2-GFP in Emi1-depleted cells. CyclinA2-GFP levels continue to increase at the beginning of the experiment, possibly since Emi1 is still functional. Later, CyclinA2-GFP levels decrease and remain low due to reactivation of APC/CCdh1 in the absence of Emi1. Two independent measurements were taken, and ten cells from one experiment are shown.
(D) Experimental measurement of p27Kip1-GFP in Emi1-depleted cells. p27Kip1-GFP is initially low and then shows a transient increase in some cells. Two independent measurements were taken, and eight cells from one experiment are shown.
(E) Experimental measurement of CyclinE1-GFP in Emi1-depleted cell. CyclinE1-GFP initially decreases and then continues to accumulate for the duration of the experiment. Two independent measurements were taken, and ten cells from one experiment are shown.
(F) Quantification of Cdk2 activity in Emi1-depleted cells. Two cells show a significant dip in Cdk2 activity. Other cells show a more moderate decrease. In all cases, individual curves represent individual cells. Three independent measurements were taken, and 11 cells from one experiment are shown.