Biomechanics of a Posterior Lumbar Motion Stabilizing Device: In Vitro Comparison to Intact and Fused Conditions

Spine (Phila Pa 1976). 2016 Jan;41(2):E55-63. doi: 10.1097/BRS.0000000000001148.

Abstract

Study design: Nondestructive flexibility tests were performed in vitro, comparing multiple conditions of fixation in a single group of specimens.

Objective: To compare the biomechanical behavior of the lumbar spine in the intact condition, after implanting a novel motion stabilizer, and after implanting a rigid fixator.

Summary of background data: Two specific scenarios that may benefit from dynamic lumbar stabilization are single-level moderate instability, where the stabilizing tissues are relatively incompetent, and juxta-level to fusion, where the last instrumented level requires intermediate stiffness ("topping off") to prevent transfer of high stresses from the stiffer fusion construct to the intact adjacent levels. Both scenarios were evaluated in vitro.

Methods: Seven human cadaveric L2-S1 segments were tested (1) intact, (2) after moderate destabilization, (3) after 2-level hybrid posterior fixation, consisting of bilateral dynamic pedicle screws at L4 interconnected with rigid rods to standard pedicle screws at L5 and S1, (4) after 2-level rigid fixation, (5) after 1-level (L4-L5) dynamic fixation, and (6) after 1-level rigid fixation. In each condition, angular range of motion (ROM) and sagittal instantaneous axis of rotation (IAR) were assessed.

Results: In 1-level constructs, dynamic hardware allowed 104% of intact ROM, whereas rigid hardware allowed 49% of intact ROM. Relative to the intact, the IAR was shifted significantly farther posterior by rigid 1-level instrumentation than by dynamic 1-level instrumentation. In 2-level constructs, the dynamic level allowed significantly greater ROM than the rigid level in all directions but allowed significantly less ROM than the intact level in all directions except axial rotation.

Conclusion: Dynamic instrumentation shifted the IAR less than rigid instrumentation, providing more favorable kinematics. This dynamic stabilizer provided 1-level ROM that was close to intact ROM during all loading modes in vitro. In the topping-off construct, the dynamic segment allowed intermediate ROM to give balanced transitional flexibility.

Level of evidence: N/A.

Publication types

  • Comparative Study
  • Research Support, Non-U.S. Gov't

MeSH terms

  • Biomechanical Phenomena
  • Bone Screws*
  • Cadaver
  • Female
  • Humans
  • Joint Instability / physiopathology
  • Joint Instability / surgery*
  • Lumbar Vertebrae / physiopathology
  • Lumbar Vertebrae / surgery*
  • Male
  • Materials Testing
  • Middle Aged
  • Range of Motion, Articular
  • Spinal Fusion / instrumentation*
  • Spinal Fusion / methods
  • Stress, Mechanical