Format

Send to

Choose Destination
PLoS One. 2015 Jul 13;10(7):e0132250. doi: 10.1371/journal.pone.0132250. eCollection 2015.

Impact of Software Settings on Multiple-Breath Washout Outcomes.

Author information

1
University Children's Hospital Basel, UKBB, 4031, Basel, Switzerland.
2
University Children's Hospital Zurich, 8032, Zurich, Switzerland.
3
University Children's Hospital Basel, UKBB, 4031, Basel, Switzerland; University Children's Hospital Bern, 3010, Bern, Switzerland.

Abstract

BACKGROUND AND OBJECTIVES:

Multiple-breath washout (MBW) is an attractive test to assess ventilation inhomogeneity, a marker of peripheral lung disease. Standardization of MBW is hampered as little data exists on possible measurement bias. We aimed to identify potential sources of measurement bias based on MBW software settings.

METHODS:

We used unprocessed data from nitrogen (N2) MBW (Exhalyzer D, Eco Medics AG) applied in 30 children aged 5-18 years: 10 with CF, 10 formerly preterm, and 10 healthy controls. This setup calculates the tracer gas N2 mainly from measured O2 and CO2concentrations. The following software settings for MBW signal processing were changed by at least 5 units or >10% in both directions or completely switched off: (i) environmental conditions, (ii) apparatus dead space, (iii) O2 and CO2 signal correction, and (iv) signal alignment (delay time). Primary outcome was the change in lung clearance index (LCI) compared to LCI calculated with the settings as recommended. A change in LCI exceeding 10% was considered relevant.

RESULTS:

Changes in both environmental and dead space settings resulted in uniform but modest LCI changes and exceeded >10% in only two measurements. Changes in signal alignment and O2 signal correction had the most relevant impact on LCI. Decrease of O2 delay time by 40 ms (7%) lead to a mean LCI increase of 12%, with >10% LCI change in 60% of the children. Increase of O2 delay time by 40 ms resulted in mean LCI decrease of 9% with LCI changing >10% in 43% of the children.

CONCLUSIONS:

Accurate LCI results depend crucially on signal processing settings in MBW software. Especially correct signal delay times are possible sources of incorrect LCI measurements. Algorithms of signal processing and signal alignment should thus be optimized to avoid susceptibility of MBW measurements to this significant measurement bias.

PMID:
26167682
PMCID:
PMC4500401
DOI:
10.1371/journal.pone.0132250
[Indexed for MEDLINE]
Free PMC Article

Supplemental Content

Full text links

Icon for Public Library of Science Icon for PubMed Central
Loading ...
Support Center