Format

Send to

Choose Destination
J Med Phys. 2014 Oct;39(4):219-24. doi: 10.4103/0971-6203.144485.

Results of 1 year of clinical experience with independent dose calculation software for VMAT fields.

Author information

1
Department of Medical Physics, Santa Lucia Universitary Hospital, Cartagena, Spain.
2
Department of Radiology and Physical Medicine, Faculty of Medicine, University of Murcia, Spain.

Abstract

It is widely accepted that a redundant independent dose calculation (RIDC) must be included in any treatment planning verification procedure. Specifically, volumetric modulated arc therapy (VMAT) technique implies a comprehensive quality assurance (QA) program in which RIDC should be included. In this paper, the results obtained in 1 year of clinical experience are presented. Eclipse from Varian is the treatment planning system (TPS), here in use. RIDC were performed with the commercial software; Diamond(®) (PTW) which is capable of calculating VMAT fields. Once the plan is clinically accepted, it is exported via Digital Imaging and Communications in Medicine (DICOM) to RIDC, together with the body contour, and then a point dose calculation is performed, usually at the isocenter. A total of 459 plans were evaluated. The total average deviation was -0.3 ± 1.8% (one standard deviation (1SD)). For higher clearance the plans were grouped by location in: Prostate, pelvis, abdomen, chest, head and neck, brain, stereotactic radiosurgery, lung stereotactic body radiation therapy, and miscellaneous. The highest absolute deviation was -0.8 ± 1.5% corresponding to the prostate. A linear fit between doses calculated by RIDC and by TPS produced a correlation coefficient of 0.9991 and a slope of 1.0023. These results are very close to those obtained in the validation process. This agreement led us to consider this RIDC software as a valuable tool for QA in VMAT plans.

KEYWORDS:

Clinical experience; VMAT; diamond; redundant independent calculation

Supplemental Content

Full text links

Icon for PubMed Central
Loading ...
Support Center