Format

Send to

Choose Destination
See comment in PubMed Commons below
J Mech Behav Biomed Mater. 2014 Aug;36:98-108. doi: 10.1016/j.jmbbm.2014.04.007. Epub 2014 Apr 18.

Effect of dissolution/precipitation on the residual stress redistribution of plasma-sprayed hydroxyapatite coating on titanium substrate in simulated body fluid (SBF).

Author information

1
Department of Materials Science, Maejo University, Chiangmai 50290, Thailand; Department of System Safety, Nagaoka University of Technology, Niigata 940-2188, Japan.
2
Department of System Safety, Nagaoka University of Technology, Niigata 940-2188, Japan. Electronic address: otsuka@vos.nagaokaut.ac.jp.
3
Department of System Safety, Nagaoka University of Technology, Niigata 940-2188, Japan.

Abstract

The residual stress distributions in hydroxyapatite (HAp) coating with and without mixed hydroxyapatite/titanium (HAp/Ti) bond coating on commercially pure Titanium substrate (cp-Ti) were evaluated by Raman piezo-spectroscopy analysis. The Raman shifted position 962cm(-1), which is the symmetrical stretching of surrounded oxygen atoms with phosphorous atom ( [Formula: see text] ), was referred to analyses of stress dependency. The piezo-spectroscopic coefficient, which is a Raman shift value per stress (cm(-1)/GPa), was fitted from the result of four-points bending test of rectangular HAp bar and as-sprayed HAp on Zn plate. The calculated values were 3.89cm(-1)/GPa for the former and 7.11cm(-1)/GPa for the latter. By using these calibrations, the compressive residual stress in HAp coating with HAp/Ti bond coating (HA-B) has been found to be distributed in the range of -137MPa to -75MPa. For the heat-treated HAp coating (HA-B-HT) specimen, the compressive residual stresses placed in the range of -40--22MPa. The changes in the values of residual stress of the HAp coating after immersion in SBF were also evaluated. The residual stress in HA-WB specimens tend to change from compressive to tensile after 30 days immersion. The HA-B-HT specimens exhibited similar behavior and reached to zero stress after the immersion. The mechanism of the changes in residual stress would be the effect of stress redistribution around melted calcium phosphate particles to remained HAp splats.

KEYWORDS:

Calcium phosphate; Hydroxyapatite; Plasma-spray coating; Raman spectroscopy; Residual stress; Simulated body Fluid

PMID:
24821139
DOI:
10.1016/j.jmbbm.2014.04.007
[Indexed for MEDLINE]
PubMed Commons home

PubMed Commons

0 comments
How to join PubMed Commons

    Supplemental Content

    Full text links

    Icon for Elsevier Science
    Loading ...
    Support Center