Research on the particular temperature-induced surface shape of a National Ignition Facility deformable mirror

Qiao Xue; Lei Huang; Ping Yan; Mali Gong; Zexin Feng; Yuntao Qiu; Tenghao Li; Guofan Jin

doi:10.1364/AO.52.000280

Research on the particular temperature-induced surface shape of a National Ignition Facility deformable mirror

Appl Opt. 2013 Jan 10;52(2):280-7. doi: 10.1364/AO.52.000280.

Authors

Qiao Xue¹, Lei Huang, Ping Yan, Mali Gong, Zexin Feng, Yuntao Qiu, Tenghao Li, Guofan Jin

Affiliation

¹ Center for Photonics and Electronics, State Key Laboratory of Tribology, Department of Precision Instruments, Tsinghua University, Beijing 100084, China.

PMID: 23314646
DOI: 10.1364/AO.52.000280

Abstract

We investigate the changes in the shape of a deformable mirror used at the National Ignition Facility caused by differences in temperature between the working environment and the mounting temperature of the mirror. In general, the temperature-induced profile change of the mirror is dominated by a few low-order aberrations, which mainly result in defocus. However, after these low-order distortions are corrected, there remain special, higher-order, surface distortions caused by the particular arrangement, construction, and mounting of the mirror actuators. This work analyzes these special aberrations, and their dependence on the particular actuator design, using the finite element method. Experiments are carried out to verify the computational results, and finally, design considerations to help minimize the temperature-induced high-order aberrations are suggested.