Format

Send to

Choose Destination
Am J Orthod Dentofacial Orthop. 2010 Oct;138(4):435-441. doi: 10.1016/j.ajodo.2008.10.021.

Influence of decontamination procedures on shear forces after contamination with blood or saliva.

Author information

1
Assistant professor, Clinic of Orthodontics and Pedodontics, University of Basel, Basel, Switzerland. Electronic address: lorenz.brauchli@unibas.ch.
2
Undergraduate student, Clinic of Orthodontics and Pedodontics, University of Basel, Basel, Switzerland.
3
Engineer, Clinic of Orthodontics and Pedodontics, University of Basel, Basel, Switzerland.
4
Professor and dean, Clinic of Orthodontics and Pedodontics, University of Basel, Basel, Switzerland.

Abstract

INTRODUCTION:

Despite rapid development in adhesive technology, contamination of bonding surfaces remains a major problem. The aims of this study were to evaluate the influence of contamination on bond strength and to investigate possible decontamination procedures.

METHODS:

Four bonding systems were evaluated for their shear bond strengths under 5 bonding situations: control (without contamination and decontamination); contamination with blood; contamination with saliva; decontamination with water and air, and repriming after blood contamination; and decontamination with water and air, and repriming after saliva contamination. The 25 specimens of each group consisted of composite blocks bonded to bovine teeth. Shear forces were measured with a testing machine after thermocycling.

RESULTS:

The 3 composite primers showed similar behavior. With the exception of Transbond SEP (3M Unitek, Monrovia, Calif) with saliva contamination, all contaminated samples showed greatly reduced shear forces. The control and decontaminated groups showed shear forces about 20 MPa. The resin-modified glass ionomer, however, did not reach clinically sufficient bond strengths in either setup.

CONCLUSIONS:

Decontamination with water and air and repriming is sufficient after contamination with blood or saliva. Etching again is not necessary. The bond strength of Transbond SEP was not significantly altered by saliva contamination and can be recommended for conventional bonding procedures.

PMID:
20889048
DOI:
10.1016/j.ajodo.2008.10.021
[Indexed for MEDLINE]

Supplemental Content

Full text links

Icon for Elsevier Science
Loading ...
Support Center