Send to

Choose Destination
See comment in PubMed Commons below
Environ Sci Technol. 2005 Mar 1;39(5):1338-45.

TCE dechlorination rates, pathways, and efficiency of nanoscale iron particles with different properties.

Author information

  • 1Department of Civil & Environmental Engineering, Carnegie Mellon University, Pittsburgh, Pennsylvania 15213-3890, USA.


Nanoscale Fe0 particles are a promising technology for in situ remediation of trichloroethene (TCE) plumes and TCE-DNAPL source areas, butthe physical and chemical properties controlling their reactivity are not yet understood. Here, the TCE reaction rates, pathways, and efficiency of two nanoscale Fe0 particles are measured in batch reactors: particles synthesized from sodium borohydride reduction of ferrous iron (Fe/B) and commercially available particles (RNIP). Reactivity was determined under iron-limited (high [TCE]) and excess iron (low [TCE]) conditions and with and without added H2. Particle efficiency, defined as the fraction of the Fe0 in the particles that is used to dechlorinate TCE, was determined under iron-limited conditions. Both particles had a core/shell structure and similar specific surface areas (approximately 30 m2/g). Using excess iron, Fe/B transformed TCE into ethane (80%) and C3-C6 coupling products (20%). The measured surface area normalized pseudo-first-order rate constant for Fe/B (1.4 x 10(-)2 L.h(-1).m(-2) is approximately 4-fold higher than for RNIP (3.1 x 10-(3) L.h(-1).m(-2). All the Fe0 in Fe/B was accessible for TCE dechlorination, and 92 +/- 0.7% of the Fe0 was used to reduce TCE. For Fe/B, H2 evolved from reduction of water (H+) was subsequently used for TCE dechlorination, and adding H2 to the reactor increased both the dechlorination rate and the mass of TCE reduced, indicating that a catalytic pathway exists. RNIP yielded unsaturated products (acetylene and ethene). Nearly half (46%) of the Fe0 in RNIP was unavailable for TCE dechlorination over the course of the experiment and remained in the particles. Adding H2 did not change the reaction rate or efficiency of RNIP. Despite this, the mass of TCE dechlorinated per mass of Fe0 added was similar for both particles due to the less saturated products formed from RNIP. The oxide shell composition and the boron content are the most likely causes for the differences between the particle types.

[PubMed - indexed for MEDLINE]
PubMed Commons home

PubMed Commons

How to join PubMed Commons

    Supplemental Content

    Loading ...
    Support Center