This study compared monomer conversion (DC), the per cent linear polymerization shrinkage (%LS), the wall-to-wall contraction pattern (per cent of peripheral opening, %DM, and maximal marginal gap, MG) and depth of cure (DOC), of a hybrid resin composite (Spectrum TPH) exposed to different types of light-curing units and exposure modes (Virtuoso-PAC, Elipar TriLight-QTH, and FreeLight-LED). The QTH and LED units were used in two curing modes: the exponential ramp and the continuous output modes. Monomer conversion was investigated by micro Multiple Internal Reflection (MIR)-Fourier-transform infrared (FTIR) spectroscopy and %LS was measured by the deflective disc method. The wall-to-wall contraction method used a cylindrical cavity model in extracted human teeth. The per cent debonded margins relative to the cavity periphery (%DM) and the width of maximum gap (MG) was evaluated. The DOC was determined using Vickers microhardness measurements (200 g load, 20 s) at the top surface (H0), at 2 mm (H2) and at 4 mm (H4) depths, and the results expressed as H2/H0 and H4/H0 ratios. Significantly lower %DC and %LS values were provided by PAC and LED units. No differences were found in %DM among the curing units and PAC exhibited the highest MG. No significant differences were noted among light-curing groups in terms of H2/H0 microhardness values. The QTH, operated in exponential mode, resulted in the highest H4/H0 value. The exponential mode of the QTH demonstrated superior performance for the total of the characteristics evaluated.