The site of greatest airway deformation in dog lungs was located during maximum expiratory flow by use of tantalum bronchography, fiberoptic bronchoscopy, and airway pressure measurements. A series of area vs. transmural pressure curves for each of these segments of the airway was produced after stepwise changes in transmural pressure. Measurements of area were made using cinephotography to elucidate the effect of time on airway compliance. The maximum flow rate was calculated using the t = 0.1 s compliance curve of the airway. An equation was derived so that maximum flow (V) could be calculated from the area (A) and transmural pressure (Ptm) of the flow-limiting segment. This equation, V = K-A square root of Ptm, implied that if V were constant then A must vary as Ptm-1/2. It was demonstrated that the area-transmural pressure curve of the flow-limiting segment showed this relationship between A and Ptm and that the flow calculated from this equation and the data from the A-Ptm curve gave flows identical to those measured during maximum expiration. The phenomena of effort-independent flow and negative effort dependence are also explained in terms of the area-transmural pressure curve of the flow-limiting segment.