Format

Send to

Choose Destination
See comment in PubMed Commons below
Stat Med. 2000 Dec 30;19(24):3389-400.

Some practical issues in the design, monitoring and analysis of a sequential randomized trial in pressure sore prevention.

Author information

1
Northern and Yorkshire Clinical Trials and Research Unit, University of Leeds, UK. medjmb@leeds.ac.uk

Abstract

A sequential double blind (assessor and patient) triangular design was used to compare the incidence of pressure sores following elective major surgery among patients lying on a standard foam mattress with those on a dry visco-elastic polymer pad during their operation. A total of 446 patients were recruited into the trial between 1994 and 1996. Interim analyses were carried out after 181 patients were entered into the trial and then subsequently after approximately every 100 patients recruited. The trial unexpectedly reached a stopping boundary at the first interim analysis, however the Independent Data Monitoring Committee recommended continuation of the trial. They were concerned that there was a need for a larger definitive trial and about an apparent treatment by centre interaction. They required a substudy to be undertaken to further validate the subjective endpoint, and that further sensitivity analyses of the main trail endpoint should be carried out in the second interim analysis. The trial was stopped at the third interim analysis when again a stopping boundary was crossed indicating that the gel pad was associated with significantly fewer pressure sores than the standard mattress (log odds ratio -0.7, (95 per cent confidence interval (CI), -1.28, -0.11), p=0.02) (estimate CI, p-value adjusted for group sequential conduct). The design, monitoring and analysis of this trial will be presented as an example of the practical problems or non-problems encountered for the local hospitals, for the trials unit, for the data monitoring committee and for the funding committee.

PMID:
11122503
[Indexed for MEDLINE]
PubMed Commons home

PubMed Commons

0 comments

    Supplemental Content

    Loading ...
    Support Center