(I) SDS-PAGE of whole-cell samples from M. capsulatus Bath. Cell samples were taken before the addition of copper (0.3 μM copper) (lane A) and when the copper concentration in the chemostat reached 1 (lane B), 5 (lane C), 15 (lane D), 25 (lane E), 35 (lane F), 45 (lane G), 55 (lane H), 65 (lane I), and 75 (lane I) μM. Molecular mass standards (Invitrogen Mark 12 standards; 200, 116.3, 97.4, 66.3, 55.4, 36.3, 21.5, 14.4, 6, 3.5, and 2.5 kDa) are shown in lane K. Chemostat conditions and cell samplings were as described in the legend to Fig. 1. The cell sample in each lane was standardized to 1.3 × 108 cells per lane. (II) α-NT, Coomassie-stained gel illustrating the protein remaining in the 43-kDa region of an SDS-polyacrylamide gel following blotting for 1 h. The Coomassie-stained gel following transfer is included because of the poor transfer of the α subunit of the pMMO. (III and IV) Immunoblot analysis of M. capsulatus Bath cell fractions with antibodies against the α (III) and β (IV) subunits of the pMMO and with antibodies against MDH. (V) MDH was used as a non-copper-regulated protein control. Arrows to the left indicate sMMO hydroxylase polypeptides, and those to the right indicate pMMO polypeptides.