Ablation Efficiency of a Novel Thulium Fiber Laser: An In Vitro Study on Laser Setting and Fiber Usage

Introduction: To investigate the ablation efficiency of super-pulse thulium fiber laser (SPTFL) with different laser settings and fiber usage. Materials and Methods: SPTFL machine was attached with different fibers. Artificial stones were fixed in water, whereas laser fiber was driven on a platform for ablation. Pulse energy, frequency, fiber-moving speed, fiber-to-stone distance, and fiber size were adjusted in each trial. The cross-sectional area of craters on the lateral stone surface was measured for comparison of ablation rate, combined with fiber-moving speed. Results: There was a trend that the ablation rate increased as pulse energy or frequency increased. When pulse energy was set as 0.2 J and frequency was increased from 50 to 150 Hz, the cross-sectional area of the crater was enlarged from 0.21 to 0.37 mm² (p < 0.05); when the frequency was set as 100 Hz and pulse energy was increased from 0.1 to 0.3 J, the crater was enlarged from 0.10 to 0.45 mm² (p < 0.05). Furthermore, energy demonstrated greater impact on ablation rate and the crater was enlarged from 0.20 mm² in the 0.1 J × 300 Hz group to 0.44 mm² in the 0.3 J × 100 Hz group (p < 0.05). Then fiber was set at different moving speeds with the same laser setting; the ablation rate of 3 mm/second group was 3.64 times higher than 0.5 mm/second group (p < 0.05). Ablation diminished as fiber-to-stone distance grew. A 200 μm fiber produced thinner and deeper fissure than 272 and 550 μm fibers, and the ablation rate was the highest for the 200 μm fiber. Conclusion: Pulse energy is a more important factor in influencing ablation efficiency compared with frequency. Closer fiber-to-stone distance, faster fiber movement, and smaller fiber size increase ablation efficiency.