Comparison of the Power Output Between the Hang Power Clean and Hang High Pull Across a Wide Range of Loads in Weightlifters

Takei, S, Hirayama, K, and Okada, J. Comparison of the power output between the hang power clean and hang high pull across a wide range of loads in weightlifters. J Strength Cond Res 35(2S): S84-S88, 2021-The current study compared the peak power output during the hang power clean (HPC) and hang high pull (HHP) across a wide range of external loads in weightlifters. Eight weightlifters completed 1 repetition maximum (1RM) assessment for the HPC (1.59 ± 0.17 kg/body mass) and a power test for the HPC and HHP at relative loads of 40, 60, 70, 80, 90, 95, and 100% 1RM of the HPC. The ground reaction force and 2-dimensional bar position data were recorded to determine the system (barbell + body mass) kinetics and bar height, respectively. System power was calculated as force multiplied by system velocity. The HHP produced significantly greater peak power than the HPC at 40, 60, and 70% 1RM. Conversely, there was no statistical or practical difference in peak power between the exercises at 80, 90, 95, and 100% 1RM. No significant interaction was found in force at peak power, whereas velocity at peak power was significantly greater during the HHP than during the HPC at 40, 60, and 70% 1RM. In addition, significantly greater peak bar height was observed for the HHP than the HPC at 40, 60, and 70% 1RM. From the power output comparisons across loads, the HHP should be used over the HPC at loads of 40-70% 1RM, whereas the HPC and HHP can be interchangeably used at loads of 80-100% 1RM.