Influence of limestone characteristics on mercury re-emission in WFGD systems

Environ Sci Technol. 2013 Mar 19;47(6):2974-81. doi: 10.1021/es304090e. Epub 2013 Mar 5.

Abstract

This work evaluates the influence of the effect of the properties of limestones on their reactivity and the re-emission of mercury under typical wet scrubber conditions. The influence of the composition, particle size, and porosity of limestones on their reactivity and the effect of sorbent concentration, pH, redox potential, and the sulphite and iron content of the slurry on Hg(0) re-emission was assessed. A small particle size, a high porosity and a low magnesium content increased the high reactivity of the limestones. Moreover, it was found that the higher the reactivity of the sample the greater the amount of mercury captured in the scrubber. Although sulphite ions did not cause the re-emission of mercury from the suspensions of the gypsums, the limestones enriched in iron increased Hg(0) re-emission under low oxygen conditions. It was observed that the low pH values of the gypsum suspensions favored the cocapture of mercury because Fe(2+) formation was avoided. The partitioning of the mercury in the byproducts of the scrubber depended on the impurities of the limestones rather than on their particle size. No leaching of mercury from the gypsum samples occurred suggesting that mercury was either tightly bound to the impurities of the limestone or was transformed into insoluble mercury species.

Publication types

  • Research Support, Non-U.S. Gov't

MeSH terms

  • Adsorption
  • Calcium Carbonate / chemistry*
  • Calcium Sulfate / chemistry
  • Iron / analysis
  • Mercury / isolation & purification*
  • Oxidation-Reduction
  • Particle Size
  • Porosity
  • Sulfites / analysis
  • Suspensions

Substances

  • Sulfites
  • Suspensions
  • Iron
  • Mercury
  • Calcium Carbonate
  • Calcium Sulfate