We immobilized carbonic anhydrase (CA) onto the surface of membrane oxygenator of polymethyl pentene (PMP) to enhance the removal of carbon dioxide in blood by two steps. We first introduced hydroxyl groups onto PMP surface by water plasma treatment, and then coupled CA onto PMP surface by using cyanate bromide (CNBr) as a crosslinker. After plasma treatment, the contact angle with water and chemical composition of PMP surface were characterized by analysis system of surface contact angle and XPS. Using p-nitrophenyl acetate (p-NPA) as a substrate, the activity, concentration, storage stability and re-usability of immobilized CA on PMP hollow fibers were studied by ultraviolet spectrophotometer. The preliminary data showed that hydroxyl groups could be introduced on the surface of PMP by water plasma treatment, and CA with catalysis activity could be successfully introduced onto PMP surface in high immobilization efficiency. The activity of covalently immobilized CA increased with the increase of concentration of CNBr, and the maximum was 73% of the theoretical activity of CA spread on PMP surface in monolayer in studied range. Covalently immobilized CA showed higher reusability compared to physically adsorbed CA, and higher storage stability compared to free CA in solution at 37 degrees C. The method would be used potentially in the membrane oxygenator to improve the capacity of removal of carbon dioxide in blood in the future.