Display Settings:

Format

Send to:

Choose Destination
    J Phys Chem B. 2006 Nov 16;110(45):22365-73.

    Fabrication and electrical conductivity of poly(methyl methacrylate) (PMMA)/carbon black (CB) composites: comparison between an ordered carbon black nanowire-like segregated structure and a randomly dispersed carbon black nanostructure.

    Source

    School of Materials Science and Engineering, Georgia Institute of Technology, 771 Ferst Drive, Atlanta, Georgia 30332-0245, USA.

    Abstract

    Poly(methyl methacrylate) (PMMA)/carbon black (CB) composites were fabricated using two different mixing methods: (1) mechanical mixing and (2) solution mixing of the precursors, followed by compression molding. The microstructures obtained were examined by optical and scanning electron microscopy. Electrical properties were measured using impedance spectroscopy over a wide frequency range (10(-3) to +10(9) Hz). With the mechanical mixing method, a segregated structure is produced with PMMA particles forming faceted grains with carbon black particles aligning to form a network of 3D-interconnected nanowires. This microstructure allows percolation to occur at a low volume fraction of 0.26 vol % CB. In contrast, specimens made by the solution method have a microstructure where carbon black is distributed more randomly throughout the bulk, and thus, the percolation threshold is higher (2.7 vol % CB). The electrical properties of the PMMA/CB composites fabricated by the mechanical mixing method are comparable to those obtained with single-wall nanotubes as fillers.

    PMID:
    17091976
    [PubMed]

      Supplemental Content

      Icon for American Chemical Society

      Save items

      loading

      Recent activity

      Your browsing activity is empty.

      Activity recording is turned off.

      Turn recording back on

      See more...
      Write to the Help Desk