X-ray diffraction (XRD) was employed to study dental alloy-ceramic interfaces. A Au-Pd-In alloy, which requires oxidation before porcelain firing, and a Au-Pt-Pd-In alloy, which does not require oxidation before porcelain firing, were selected in this study. Alloy specimens were centrifugally cast. Specimen surfaces were metallographically polished through 0.05 microm Al2O3 slurries. A thin layer (< 50 microm) of a dental opaque porcelain was fired on the alloy surfaces with and without initial oxidation. XRD was conducted at room temperature on four types of alloy specimens: polished, oxidized, porcelain fired after alloy oxidation, and porcelain fired without initial alloy oxidation. XRD was also performed on fired opaque porcelain without an alloy substrate. The detection of prominent gold solid solution peaks from alloy-ceramic specimens indicated that the incident X-ray beam reached the alloy-ceramic interface. In2O3 and beta-Ga2O3 were identified on the oxidized Au-Pd-In alloy, while In2O3 and SnO2 were detected on the oxidized Au-Pt-Pd-In alloy. Preferred orientation was observed for all the oxides formed on the alloys. Minimum lattice parameter changes (<1%) for the gold solid solutions were observed for both alloys before and after oxidation and porcelain firing. Leucite (KAlSi2O6, TiO2, ZrO2 and SnO2 were detected on the fired opaque porcelain. For both alloys, no additional oxides were identified at the metal-ceramic interfaces beyond those present in the oxidized alloys and the opaque porcelain. Similar results were obtained from alloy-ceramic interfaces where there was no prior alloy oxidation. The results indicate the critical role of alloy surface oxides in metal-ceramic bonding and support the chemical bonding mechanism for porcelain adherence.
Copyright 2001 Kluwer Academic Publishers