Send to:

Choose Destination
See comment in PubMed Commons below
Appl Opt. 2002 Dec 20;41(36):7607-11.

Monitoring and multiplexing technique for interferometric fiber optic sensors with a linearly chirped Er:fiber laser.

Author information

  • 1Department of Electrical Engineering, Texas A&M University, College Station, Texas 77843, USA.


The monitoring of interferometer fiber optic sensors using a laser that is scanned over a wide frequency range is investigated. The interrogation technique is based on the principle that if the light-source frequency varies linearly with time, the optical signal reflected or transmitted is intensity modulated at a frequency that is proportional to the optical path difference (OPD) in the interferometer. Fourier components in the detected optical output signal then correspond to the OPDs of any interferometers that have contributed to this modulation. The temporal position of a peak in the power spectrum of this signal is proportional to the OPD of the interferometer that is responsible for that peak. A fine tuning of the OPD value is determined from the phase of the corresponding Fourier component. Experimentally, an Er:fiber laser scanned over a 48-nm range centered at 1540 nm was used to monitor intrinsic fiber Fabry-Perot interferometers (FFPIs). Variations in the laser scan rate were compensated with the optical signal modulated by a reference FFPI held at a constant temperature. The OPD measurement resolution was 3.6 nm, and the dynamic range was 1.3 x 10(7). The temperature was measured from 20 degrees C to 610 degrees C with a 0.02 degrees C resolution, and multiplexing of three of the sensors arranged in series was demonstrated.

PubMed Commons home

PubMed Commons

How to join PubMed Commons

    Supplemental Content

    Full text links

    Icon for Optical Society of America
    Loading ...
    Write to the Help Desk