Format

Send to:

Choose Destination
See comment in PubMed Commons below
J Control Release. 2001 May 14;72(1-3):203-15.

Biodegradable block copolymers for delivery of proteins and water-insoluble drugs.

Author information

  • 1MacroMed Inc., 9520 South State Street, Sandy, UT 84070, USA. macromed@macromed.com

Abstract

Release of several drugs from new ABA-type biodegradable thermal gels, ReGel, including proteins and conventional molecules, are presented. These are biodegradable, biocompatible polymers that demonstrate reverse thermal gelation properties. Organic solvents are not used in the synthesis, purification, or formulation of these polymers. The unique characteristics of ReGel hinge on the following two key properties: (1) ReGel is a water soluble, biodegradable polymer at temperatures below the gel transition temperature; (2) ReGel forms a water-insoluble gel once injected. This is consistent with a hydrophobically bonded gel state where all interactions are physical, with no covalent crosslinking. An increase in viscosity of approximately 4 orders of magnitude accompanies the sol--gel transition. The gel forms a controlled release drug depot with delivery times ranging from 1 to 6 weeks. ReGel's inherent ability to solubilize (400 to >2000-fold) and stabilize poorly soluble and sensitive drugs, including proteins is a substantial benefit. The gel provided excellent control of the release of paclitaxel for approximately 50 days. Direct intratumoral injection of ReGel/paclitaxel (OncoGel) results in a slow clearance of paclitaxel from the injection site with minimal distribution into any organ. Efficacies equivalent to maximum tolerated systemic dosing were observed at OncoGel doses that were 10-fold lower. Data on protein release (pGH, G-CSF, insulin, rHbsAg) and polymer biocompatibility are discussed.

PMID:
11389999
[PubMed - indexed for MEDLINE]
PubMed Commons home

PubMed Commons

0 comments
How to join PubMed Commons

    Supplemental Content

    Full text links

    Icon for Elsevier Science
    Loading ...
    Write to the Help Desk